BERTHOLD TECHNOLOGIES Uni-Probe LB 490 - 3.1.17 CALIBRATION  ADJUSTS LOWER CALIBRATION POINT

Uni-Probe LB 490
BERTHOLD TECHNOLOGIES GmbH & Co. KG
6 – 579
Volume 6 3 Device-specific Menus
6
3.1.17 CALIBRATION  ADJUSTS LOWER CALIBRA-
TION POINT
Set the lower calibration point.
 Define the level for the lower calibration point and confirm the
input with
OK.
IMPORTANT
Typically, the lower calibration point is at 0% level. In case of a
multi-point calibration, the adjustment will adjust all other calibra-
tion points proportionally.
Calibration is described in detail in chapter 4.
3.1.18 CALIBRATION  ADJUSTS UPPER CALIBRA-
TION POINT
Set the upper calibration point.
 Define the level for the upper calibration point and confirm the
input with
OK.