38477BA2B
7 – 692 25.5.09
5 Functional Processes Volume 7
At LE_DETECTOR_ADDRESS, enter the device ID of the respec-
tive Uni-Probe. The number is attached on the outside of each
Uni-Probe.
At
LE_DETECTOR_SETUP under LE_DETECTOR_CODE enter the
code according to the table in Volume 2, "1.6 Detector Codes"
page 2–133.
Send the entries to the Uni-Probe.
This completes the setting for our example.
If further Auxiliary Units are connected, then repeat this pro-
cess until all detectors are logged on to the Main Unit. Select
the individual detectors via
LE_DETECTOR_ENTRY.
This completes the multi-detector mode setup.
To Next Page
