Bosch Rexroth Tightening System 350 - Page 304

304/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
Fig. 6–56: Test of the results output via the System test  CS field bus data function (hexadecimals)
Table 6–54: Results in byte format (including control signals)
Byte count
Results output as byte stream
1
0 1 2 3 4 5 6 7 8 9 a b c d e f
00000000
00 00 01 20 20 20 20 31 41 42 43 44 58 58 58 58
PLC
2
Res Quality code ID code
00000010
58 00 00 00 00 00 00 00 00 54 65 73 74 76 65 72
ID code (continued) Prg Program name
00000020
73 63 68 72 61 75 62 75 6e 67 00 00 00 40 89 95
Program name (continued) M–
00000030
00 30 44 9a 00 cd a3 9b 00 20 a1 07 00 a4 ba 14
M– M T+ W– A
00000040
00 a0 25 26 00 00 00 00 00 00 00 00 00 00 00 00
A W+ ECode Ecl Not assigned
00000050
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Not assigned
00000060
00 00 00 00 00 00 00
Not assigned
1 The table shows a rough division of the data stream into the sections for control signals (PLC), ID code, and results values. A detailed assignment
can be found in Table 6–55.
2 The display in BS350 under
System test  CS field bus data (see Figures 6–55and 6–56) does not include the control signals (PLC).
Table 6–55: Meaning of the results in the output area of the data buffer for a single-channel tightening process
Name Results output Meaning of the output result
Control signal output
00 00
All control signals
1
are 0
Result
01
OK
Quality code
20 20 20 20 31
1, quality code 1
= all OK
ID code
41 42 43 44 58 58 58 58 58 00 00 00 00 00 00 00
Tightening no. 12345678-2
Program no.
0a
0x0a
= program no. 10
Program name
54 65 73 74 76 65 72 73 63 68 72 61 75 62 75 6e 67 00 00 00
Test tightening
Lower torque limit
40 89 95 00
0x00958940
= 98.000 Nm
End torque
30 44 9a 00
0x009a4430
= 101.100 Nm