354/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
MID 0019 Make the presetting for OK/NOK counter
MID 0019 revision 001
MID 0019 revision 002
Sent by: superordinate computer
This message sets the presetting for the OK counter and the NOK counter (parameter "OK counter limit") for the
counter value specified in the command ("Tightening program number" parameter)
Note: -
Revision: Number Supported by
001 Rexroth OP, Rexroth OP-Ford, Rexroth OP-BMW
002 Rexroth OP, Rexroth OP-Ford, Rexroth OP-BMW
Data field: Data 7 bytes
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 01 Invalid data
Table 6–84: MID 0019 revision 001
Parameter Comments Bytes
Tightening program number The value consists of three ASCII characters.
ID -
Value range 000 – 999
Presetting -
Example:
Tightening program number 3
Value 003
3
OK counter value The value consists of two ASCII characters.
ID -
Value range 00 – 99
Presetting -
Example:
OK counter value 9
Value 09
2
Data length revision 001
5
Table 6–85: MID 0019 revision 002
Parameter Comments Bytes
This revision includes the information from revision 001 and the following additional information:
NOK counter value The value consists of two ASCII characters.
ID -
Value range 00 – 99
Presetting -
Example:
NOK counter value 5
Value 05
2
Data length revision 002
7
To Next Page
Loading...
