Bosch Rexroth Tightening System 350 - Page 420

420/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.7.7.16 HVO messages
MID 0510 Subscription operation HVO button
MID 0511 Upload operation HVO button
MID 0511 revision 001
The messages in this section are supported as of version V2.200 of the Rexroth Tightening System 350.
Sent by: superordinate computer
As a consequence of this message, the superior computer is informed about every actuation of an HVO button
(upload confirmation HVO button, MID 0511).
Note: -
Revision:
001 (supported by Rexroth OP and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible response MID Error no. Comment
Command accepted 0005 –
Command error 0004 88 Activation for operation HVO button already
available
Sent by: Tightening controller
This message specifies which button has been operated on the HVO.
Note: -
Revision:
001 (supported by Rexroth OP and Rexroth OP-BMW)
Data field: Header and parameter value, 1 byte
Possible response MID Error no. Comment
Upload operation HVO button
acknowledgement
0512 –
Table 6–117: MID 0511 revision 001
Parameter Comments Bytes
Button Any change to the "Reset" or "Railnetbypass" buttons on the HVO is
identified by a unique number:
– 0: "Reset" button (pushbutton) actuated
– 1: "Railnetbypass" button pushed
– 2: "Railnetbypass" button not pushed
Value range 0–9
Presetting -
Example:
Signal Reset
Button 0
1
Data length revision 001
1