155
Bruker Optik GmbH IFS 125M User Manual
Web Interface 8
8.3.2.5 Automation diagnostics page
The List of Commands includes the following important information:
• Name: command to control a component, e.g. switching the laser on or off, or to
set a parameter, e.g. preamplifier gain
• Description: component or parameter which the corresponding command con-
cerns
• Current value: displays the current command value
• Ready: indicates that the respective component is in operating condition
i
If a unit or a command has not been used since the last power up, the Ready field may
be empty.
• Error: indicates an error status of the component in question.
Definition
A
Status message
Table 8.11: Components of automation diagnostics page
Figure 8.12: Automation diagnostics page
A
To Next Page
Loading...
