Cisco Catalyst 4500 Series - Page 52

Contents
52
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Configuring SNMP Traps 64-16
Configuring Fault Alarms 64-16
Configuring IP SLAs CFM Operation 64-18
Manually Configuring an IP SLAs CFM Probe or Jitter Operation 64-19
Configuring an IP SLAs Operation with Endpoint Discovery 64-21
Configuring CFM on C-VLAN (Inner VLAN) 64-24
Feature Support and Behavior 64-26
Platform Restrictions and Limitations 64-26
Understanding CFM ITU-T Y.1731 Fault Management 64-27
Y.1731 Terminology 64-27
Alarm Indication Signals 64-28
Ethernet Remote Defect Indication 64-28
Multicast Ethernet Loopback 64-29
Configuring Y.1731 Fault Management 64-29
Default Y.1731 Configuration 64-29
Configuring ETH-AIS 64-29
Using Multicast Ethernet Loopback 64-31
Managing and Displaying Ethernet CFM Information 64-31
About Ethernet OAM Protocol 64-33
OAM Features 64-34
OAM Messages 64-34
Enabling and Configuring Ethernet OAM 64-35
Ethernet OAM Default Configuration 64-35
Ethernet OAM Configuration Guidelines 64-35
Enabling Ethernet OAM on an Interface 64-36
Enabling Ethernet OAM Remote Loopback 64-37
Configuring Ethernet OAM Link Monitoring 64-38
Configuring Ethernet OAM Remote Failure Indications 64-42
Configuring Ethernet OAM Templates 64-45
Displaying Ethernet OAM Protocol Information 64-49
Ethernet CFM and Ethernet OAM Interaction 64-51
Configuring Ethernet OAM Interaction with CFM 64-51
Configuring the OAM Manager 64-52
Enabling Ethernet OAM 64-52
Example: Configuring Ethernet OAM and CFM 64-53
Configuring Y.1731 (AIS and RDI) 65-1
AIS and RDI Terminology 65-1
About Y.1731 65-2