Comtech EF Data SLM-5650B - Page 109

SLM-5650B Satellite Modem
Revision 2
Front Panel Operation 5–25 MN-SLM-5650B
Option Settings
Eb/No
Set the target Eb/No for AUPC at 3.2 to 16.0 dB.
RateofChange
Set the maximum tracking rate at
0.5 to 6.0 dB per minute (in 0.5 dB
increments).
(CONFIG:) AUPC  Local Carrier Loss Action
Carrier Loss: Local: HOLD
Remote: HOLD (E)
Use thearrow keys to select Local or Remote. Press [ENT].
Option
Settings
Local Sets the action of the local modem when it loses carrier detect.
Remote
Sets the action of the local modem when the remote modem loses carrier
detect.
For either option, use the  arrow keys to select HOLD, NOMINAL, or MAXIMUM.
Press [ENT] to finish.
(CONFIG:) AUPC  Remote
Remote AUPC: Enable: Off BasebandL: Off
Tx Pattern: Off BER: Loss (E)
Use the arrow keys to select Enable, BasebandL, Tx Pattern, or BER. Press
[ENT].
Option Settings
Enable View or modify the status of the remote modem’s AUPC Enable.
BasebandL
View or modify the status of the remote modem’s I/O Loopback #1 setting.
Tx Pattern
View or modify the status of the remote modem’s Tx pattern substitution.
Note: In order to maintain compatibility with older Comtech EF Data modems, only
2047 pattern substitution is supported.
BER
Monitor BER of the remote modem. The remote modem must have Tx Pattern set to
On
and the local modem must be transmitting a 2047 pattern.
Typical for all options, use the  arrow keys to select operation as On or Off. Press
[ENT] to finish.