Comtech EF Data SLM-5650B - Page 362

SLM-5650B Satellite Modem
Revision 2
Appendix C C–34 MN-SLM-5650B
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to
Query
Clear All Stored
Events
CAE= None Command only.
Forces the software to clear the software events log.
Note: This command takes no arguments
Example: CAE=
CAE=
CAE?
CAE*
CAE#
N/A N/A
Clear All Stored
Events
CAS= None Command only.
Forces the software to clear the software statistics log.
Note: This command takes no arguments
Example: CAS=
CAS=
CAS?
CAS*
CAS#
N/A N/A
Carrier-in-Carrier
(CnC)
Frequency
Offset Range
CCF= 6 bytes Command or Query.
CnC Sweep Frequency range from 0 to 60.000 kHz
Example: CCF = 60.000
CCF=
CCF?
CCF*
CCF#
CCF? CCF=xx.xxx
(see Description
of Arguments)
Carrier-in-Carrier
(CnC) Delay
Monitor
N/A 6 bytes Query only.
When CnC is enabled and locked, the delay of the interferer is
readable in microseconds.
Example 1: CDM = 229500 (229.5 mSec)
Example 2: CDM = 999999 (not locked or CnC not enabled)
N/A CDM? CDM=xxxxxx
(see Description
of Arguments)
Carrier-in-Carrier
(CnC)
Frequency
Offset Monitor
N/A
6 bytes
Query only.
When CnC is enabled and locked, the estimated frequency offset
between the desired signal and the interferer is readable in kHz.
Example 1: CFM = +001.0 (1 kHz)
Example 2: CFM = 9999.9 (not locked or CnC not enabled)
N/A
CFM?
CFM=xxxx.x
(see Description
of Arguments)