Comtech EF Data SLM-5650B - Page 361

SLM-5650B Satellite Modem
Revision 2
Appendix C C–33 MN-SLM-5650B
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to
Query
CnC-APC State
(cont)
(IF)
09 = OK(Partial) – Distant power approaches minimum value
(L-Band)
10 = OK(Partial) – Distant power approaches maximum value
11 = OK(Partial) – Distant power approaches limit set by max
power level increase
12 = OK(Partial) – Incomplete
13 = No APC Frame Sync
14 = CnC Ratio Problem
15 = Local Eb/No too high
16 = Distant Eb/No too high
17 = Distant End ReBalance failed
18 = Distant End No Response
19 = Fail-Calculate Mismatch
20 = CnC Ratio too high
21 = Please run again
22 = APC is active
23 = Local margin too low
24 = Distant margin too low
25 = Rx Data Rate < 64 kbps
26 = Tx Data Rate < 64 kbps
27 = Local RSL too low
28 = Distant RSL too low
29 = Unrecognized Modem
Example: APS = 00
Buffer Fill State N/A 2 bytes Query only.
xx = value of the buffer fill state, between 1 to 99%.
Returns 00 if demodulator is unlocked.
Example: BFS = 33 (selects 33%)
N/A BFS? BFS=xx
(see Description
of Arguments)