Comtech EF Data SLM-5650B - Page 368

SLM-5650B Satellite Modem
Revision 2
Appendix C C–40 MN-SLM-5650B
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to
Query
Equipment ID
(cont)
x = Rx Data Rate
0 = None
1 = 10,000 kbps
2 = 20,000 kbps,
3 = 51,840 kbps
4 = 155,520 kbps
5 = 2,500 kbps
Example: EID = 565B0000000000000 indicates SLM-5650B with
no options installed
Force Modem
Reboot
FRB=
None
Command only.
Reboot the modem.
Example: FRB=
FRB=
FRB#
N/A
N/A
Initialize Events
Pointer
IEP= None Command only.
Resets internal pointer to allow RNE? queries to start at the
beginning of the stored events log.
Example: IEP=
IEP=
IEP#
N/A N/A
Software Image IMG= 1 byte Command or Query.
Next Reboot Image, where:
1 = Bulk Image #1
2 = Bulk Image #2
Example: IMG = 1 (Image #1 will be active after next reboot)
IMG=
IMG?
IMG*
IMG#
IMG? IMG=x
(see Description
of Arguments)
IP Address
IPA=
18 bytes
Command or Query.
Used to set the IP address and network prefix for the 10/100Base-
Tx Ethernet management port, in the format xxx.xxx.xxx.xxx.yy,
where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (0-31)
Example: 010.006.030.001.24
IPA=
IPA?
IPA*
IPA#
IPA?
IPA=xxx.xxx.xxx
.xxx.yy
(see Description
of Arguments)