Comtech EF Data SLM-5650B - Page 386

SLM-5650B Satellite Modem
Revision 2
Appendix C C–58 MN-SLM-5650B
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to
Query
Remote Modem
AUPC Enable
RPC= 1 byte Command or Query.
Remote Modem AUPC Control, where:
0 = Off
1 = On
Example: RPC = 1 (Turn on remote modem AUPC Control)
RPC=
RPC?
RPC*
RPC#
RPC? RPC=x
(see Description of
Arguments)
Remote Modem
BERT BER
N/A
6 bytes
Query only.
Unit returns the value of the remote modem’s BERT BER in the
form a.b x 10
-c
. First three bytes are the value. Last two bytes are
the exponent. Returns 0.0E00 if the BERT is not synchronized to a
pattern.
Example: RPE = 4.0E06
N/A
RPE?
RPE=a.bEcc
(see Description of
Arguments)
Remote Modem
I/O Loopback
RPL= 1 byte Command or Query.
Remote Modem I/O Loopback Mode, where:
0 = Off
1 = On
Example: RPL = 1 (Turn on remote modem AUPC Control)
RPL=
RPL?
RPL*
RPL#
RPL? RPL=x
(see Description of
Arguments)