------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 5
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: 1-0(0-3387)
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer Stack-unit ID: 2
Stack-unit SW Version: 1-0(0-3387)
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Disabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
stack-unit Config: succeeded Nov 25 2014 15:29:58
Start-up Config: succeeded Nov 25 2014 15:29:58
Runtime Event Log: succeeded Nov 25 2014 15:29:58
Running Config: succeeded Nov 25 2014 15:29:58
ACL Mgr: succeeded Nov 25 2014 15:29:58
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
Management Access on Stacks
You can access the stack via the console port or VTY line.
• Console access — You may access the stack through the console port of the master unit (stack
manager) only. Similar to a standby RPM, the console port of the standby unit does not provide
management capability; only a limited number of commands are available. Member units provide a
limited set of commands.
• Remote access — You may access the master unit and standby unit in a stack through the dedicated
management Ethernet interfaces with SNMP, SSH, or via Telnet.
Example of Accessing Non-Master Units on a Stack via the Console Port
-----------------CONSOLE ACCESS ON A STANDBY----------------------------
Dell(standby)#?
cd Change current directory
clear Reset functions
copy Copy from one file to another
delete Delete a file
dir List files on a filesystem
disable Turn off privileged commands
Stacking 1018
To Next Page
Loading...
