R 100 Active T Fo 1/49
R 300 Active T Fo 1/51
Configuring the Sample Remote Port Mirroring
Remote port mirroring requires a source session (monitored ports on different source switches), a reserved
tagged VLAN for transporting mirrored traffic (configured on source, intermediate, and destination switches),
and a destination session (destination ports connected to analyzers on destination switches).
Table 65. Configuration Steps for RPM
Step Command Purpose
1 configure terminal
Enter global configuration mode.
2
monitor session <id> type rpm The <id> needs to be unique and not already defined in
the box specifying type as 'rpm' defines a RPM session.
3 source Interface | Range
Specify the port or list of ports that needs to be
monitored
4
direction Specify rx, tx or both in case to monitor ingress/egress
or both ingress and egress packets on the specified
port..
5
rpm source-ip <id> dest-ip <id> Specify the source ip address and the destination ip
where the packet needs to be sent.
6
<no> flow-based enable Specify flow-based enable for mirroring on a flow by
flow basis and also for vlan as source.
7
no enable (Optional) No disable command is mandatory in order
for a rpm session to be active.
Configuring the sample Source Remote Port Mirroring
Dell(conf)#interface vlan 10
Dell(conf-if-vl-10)#mode remote-port-mirroring
Dell(conf-if-vl-10)#tagged te 1/4
Dell(conf-if-vl-10)#exit
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source te 1/5 destination remote-vlan 10 dir rx
Dell(conf-mon-sess-1)#no disable
Dell(conf-mon-sess-1)#exit
Dell(conf)#inte vlan 100
Dell(conf-if-vl-100)#tagged te 1/7
Dell(conf-if-vl-100)#exit
Dell(conf)#interface vlan 20
Dell(conf-if-vl-20)#mode remote-port-mirroring
Dell(conf-if-vl-20)#tagged te 1/6
Dell(conf-if-vl-20)#exit
Dell(conf)#monitor session 2 type rpm
Dell(conf-mon-sess-2)#source vlan 100 destination remote-vlan 20 dir rx
Dell(conf-mon-sess-2)#no disable
Dell(conf-mon-sess-2)#flow-based enable
Dell(conf-mon-sess-2)#exit
Port Monitoring 801
To Next Page
Loading...
