Dell S4048T User Manual

Interfaces
This chapter describes interface types, both physical and logical, and how to configure them with Dell
Networking Operating System (OS).
The system supports 10 Gigabit Ethernet and 40 Gigabit Ethernet interfaces.
NOTE: Only Dell-qualified optics are supported on these interfaces. Non-Dell 40G optics are set to error-
disabled state.
Basic Interface Configuration
• Interface Types
• View Basic Interface Information
• Enabling a Physical Interface
• Physical Interfaces
• Management Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• Port Channel Interfaces
Advanced Interface Configuration
• Bulk Configuration
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Splitting QSFP Ports to SFP+ Ports
• Link Dampening
• Link Bundle Monitoring
• Ethernet Pause Frames
• Configure the MTU Size on an Interface
• Port-pipes
• Auto-Negotiation on Ethernet Interfaces
• View Advanced Interface Information
Topics:
22
Interfaces 451

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)