Dell S4048T User Manual

To set global communication parameters for all RADIUS server hosts, use the following commands.
• Set a time interval after which a RADIUS host server is declared dead.
CONFIGURATION mode
radius-server deadtime seconds
• seconds: the range is from 0 to 2147483647. The default is 0 seconds.
• Configure a key for all RADIUS communications between the system and RADIUS server hosts.
CONFIGURATION mode
radius-server key [encryption-type] key
• encryption-type: enter 7 to encrypt the password. Enter 0 to keep the password as plain text.
• key: enter a string. The key can be up to 42 characters long. You cannot use spaces in the key.
• Configure the number of times Dell Networking OS retransmits RADIUS requests.
CONFIGURATION mode
radius-server retransmit retries
• retries: the range is from 0 to 100. Default is 3 retries.
• Configure the time interval the system waits for a RADIUS server host response.
CONFIGURATION mode
radius-server timeout seconds
• seconds: the range is from 0 to 1000. Default is 5 seconds.
To view the configuration of RADIUS communication parameters, use the show running-config
command in EXEC Privilege mode.
Monitoring RADIUS
To view information on RADIUS transactions, use the following command.
• View RADIUS transactions to troubleshoot problems.
EXEC Privilege mode
debug radius
Security 919

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)