Displaying Tracked Objects
To display the currently configured objects used to track Layer 2 and Layer 3 interfaces, and IPv4 and IPv6
routes, use the following show commands.
To display the configuration and status of currently tracked Layer 2 or Layer 3 interfaces, IPv4 or IPv6 routes,
or a VRF instance, use the
show track command. You can also display the currently configured per-
protocol resolution values used to scale route metrics when tracking metric thresholds.
• Display the configuration and status of currently tracked Layer 2 or Layer 3 interfaces, IPv4 or IPv6 routes,
and a VRF instance.
show track [object-id [brief] | interface [brief] [vrf vrf-name] | ip route
[brief] [vrf vrf-name] | resolution | vrf vrf-name [brief] | brief]
• Use the show running-config track command to display the tracking configuration of a specified
object or all objects that are currently configured on the router.
show running-config track [object-id]
Examples of Viewing Tracked Objects
Dell#show track
Track 1
IP route 23.0.0.0/8 reachability
Reachability is Down (route not in route table)
2 changes, last change 00:16:08
Tracked by:
Track 2
IPv6 route 2040::/64 metric threshold
Metric threshold is Up (STATIC/0/0)
5 changes, last change 00:02:16
Metric threshold down 255 up 254
First-hop interface is TenGigabitEthernet 1/2
Tracked by:
VRRP TenGigabitEthernet 2/30 IPv6 VRID 1
Track 3
IPv6 route 2050::/64 reachability
Reachability is Up (STATIC)
5 changes, last change 00:02:16
First-hop interface is TenGigabitEthernet 1/2
Tracked by:
VRRP TenGigabitEthernet 2/30 IPv6 VRID 1
Track 4
Interface TenGigabitEthernet 1/4 ip routing
IP routing is Up
3 changes, last change 00:03:30
Tracked by:
Example of the show track brief Command
Router# show track brief
ResId Resource Parameter
State LastChange
1 IP route reachability 10.16.0.0/16
Object Tracking 706
To Next Page
Loading...
