BGP Configuration
To enable the BGP process and begin exchanging information, assign an AS number and use commands in
ROUTER BGP mode to configure a BGP neighbor.
By default, BGP is disabled.
By default, Dell Networking OS compares the MED attribute on different paths from within the same AS (the
bgp always-compare-med command is not enabled).
NOTE: In Dell Networking OS, all newly configured neighbors and peer groups are disabled. To enable a
neighbor or peer group, enter the neighbor {ip-address | peer-group-name} no shutdown
command.
The following table displays the default values for BGP on Dell Networking OS.
Table 12. BGP Default Values
Item Default
BGP Neighbor Adjacency changes All BGP neighbor changes are logged.
Fast External Fallover feature Disabled
Graceful Restart feature Disabled
Local preference 100
MED 0
Route Flap Damping Parameters
half-life = 15 minutes
reuse = 750
suppress = 2000
max-suppress-time = 60 minutes
Distance
external distance = 20
internal distance = 200
local distance = 200
Timers
keepalive = 60 seconds
holdtime = 180 seconds
Add-path Disabled
Border Gateway Protocol IPv4 (BGPv4) 226
To Next Page
Loading...
