Dell S4048T User Manual

Configuring Contact and Location
Information using SNMP
You may configure system contact and location information from the Dell Networking system or from the
management station using SNMP.
To configure system contact and location information from the Dell Networking system and from the
management station using SNMP, use the following commands.
• (From a Dell Networking system) Identify the system manager along with this person’s contact information
(for example, an email address or phone number).
CONFIGURATION mode
snmp-server contact text
You may use up to 55 characters.
The default is None.
• (From a Dell Networking system) Identify the physical location of the system (for example, San Jose, 350
Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmp-server location text
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the system manager along with this person’s contact information
(for example, an email address or phone number).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysContact.0 s “contact-info”
You may use up to 55 characters.
The default is None.
• (From a management station) Identify the physical location of the system (for example, San Jose, 350
Holger Way, 1st floor lab, rack A1-1).
CONFIGURATION mode
snmpset -v version -c community agent-ip sysLocation.0 s “location-info”
You may use up to 55 characters.
The default is None.
Simple Network Management Protocol (SNMP) 986

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)