Dell S4048T - Marking Egress Packets with a DEI Value

Te 2/9 1 Red
Te 2/10 0 Yellow
Marking Egress Packets with a DEI Value
On egress, you can set the DEI value according to a different mapping than ingress.
For ingress information, refer to Honoring the Incoming DEI Value.
To mark egress packets, use the following command.
• Set the DEI value on egress according to the color currently assigned to the packet.
INTERFACE mode
dei mark {green | yellow} {0 | 1}
Example of Viewing DEI-Marking Configuration
To display the DEI-marking configuration, use the show interface dei-mark [interface slot/
port[/subport] ] in EXEC Privilege mode.
Dell#show interface dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
--------------------------------
Te 1/1 Green 0
Te 1/1 Yellow 1
Te 2/9 Yellow 0
Te 2/10 Yellow 0
Service Provider Bridging 959