EasyManuals Logo

Dell S4048T User Manual

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #987 background imageLoading...
Page #987 background image
Subscribing to Managed Object Value
Updates using SNMP
By default, the Dell Networking system displays some unsolicited SNMP messages (traps) upon certain events
and conditions.
You can also configure the system to send the traps to a management station. Traps cannot be saved on the
system.
Dell Networking OS supports the following three sets of traps:
RFC 1157-defined traps — coldStart, warmStart, linkDown, linkUp, authenticationFailure, and
egpNeighbborLoss.
Dell Networking enterpriseSpecific environment traps — fan, supply, and temperature.
Dell Networking enterpriseSpecific protocol traps — bgp, ecfm, stp, and xstp.
To configure the system to send SNMP notifications, use the following commands.
1 Configure the Dell Networking system to send notifications to an SNMP server.
CONFIGURATION mode
snmp-server host ip-address [traps | informs] [version 1 | 2c |3] [community-
string]
To send trap messages, enter the keyword traps.
To send informational messages, enter the keyword informs.
To send the SNMP version to use for notification messages, enter the keyword version.
To identify the SNMPv1 community string, enter the name of the community-string.
2 Specify which traps the Dell Networking system sends to the trap receiver.
CONFIGURATION mode
snmp-server enable traps
Enable all Dell Networking enterprise-specific and RFC-defined traps using the snmp-server enable
traps command from CONFIGURATION mode.
Enable all of the RFC-defined traps using the snmp-server enable traps snmp command from
CONFIGURATION mode.
3 Specify the interfaces out of which Dell Networking OS sends SNMP traps.
CONFIGURATION mode
snmp-server trap-source
Simple Network Management Protocol (SNMP) 987

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S4048T and is the answer not in the manual?

Dell S4048T Specifications

General IconGeneral
Switching Capacity1.44 Tbps
Rack Units1U
Form FactorRack-mountable
Power DeviceInternal power supply
Power RedundancyOptional
Product TypeSwitch
Jumbo Frame SupportYes
Routing ProtocolOSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management ProtocolSNMP, RMON, Telnet, SSH
FeaturesQuality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)17.3 in x 16 in x 1.7 in
Operating Temperature0°C to 40 °C
Operating Humidity10% to 90% (non-condensing)

Related product manuals