Dell S4048T User Manual

ip pim dr-priority priority-value
• Change the interval at which a router sends hello messages.
INTERFACE mode
ip pim query-interval seconds
• Display the current value of these parameter.
EXEC Privilege mode
show ip pim interface
Creating Multicast Boundaries and
Domains
A PIM domain is a contiguous set of routers that all implement PIM and are configured to operate within a
common boundary defined by PIM multicast border routers (PMBRs).
PMBRs connect each PIM domain to the rest of the Internet.
Create multicast boundaries and domains by filtering inbound and outbound bootstrap router (BSR) messages
per interface. The following command is applied to the subsequent inbound and outbound updates. Timeout
removes existing BSR advertisements.
• Create multicast boundaries and domains by filtering inbound and outbound BSR messages per interface.
ip pim bsr-border
• Remove candidate RP advertisements.
clear ip pim rp-mapping
PIM Sparse-Mode (PIM-SM) 785

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)