EasyManua.ls Logo

Dell S4048T - Troubleshooting Packet Loss; Displaying Drop Counters

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
buffer dedicated queue0 3 queue1 3 queue2 3 queue3 3 queue4 3 queue5 3 queue6 3
queue7 3
buffer dynamic 1256
!
buffer fp-uplink stack-unit 1 port-set 0 buffer-policy fsqueue-hig
buffer fp-uplink stack-unit 1 port-set 1 buffer-policy fsqueue-hig
!
Interface range tengigabitethernet 1/1 - 18
buffer-policy fsqueue-fp
Dell#show run interface tengigabitethernet 1/10
!
interface TenGigabitEthernet 1/10
no ip address
Troubleshooting Packet Loss
The show hardware stack-unit command is intended primarily to troubleshoot packet loss.
To troubleshoot packet loss, use the following commands.
show hardware stack-unit stack-unit-number cpu data-plane statistics
show hardware stack-unit stack-unit-number cpu party-bus statistics
show hardware stack-unit stack-unit-number drops unit unit-number
show hardware stack-unit stack-unit-number unit unit-number {counters | details
| port-stats [detail] | register | ipmc-replication | table-dump}
show hardware {ip | ipv6 | mac} {eg-acl | in-acl} stack-unit stack-unit-number
port-set 0 pipeline 0-3
show hardware ip qos stack-unit stack-unit-number port-set 0
show hardware system-flow layer2 stack-unit stack-unit-number port-set 0
{counters | pipeline 0-3}
show hardware drops interface interface
show hardware buffer-stats-snapshot resource interface interface
show hardware buffer inteface interface{priority-group { id | all } | queue
{ id| all} } buffer-info
show hardware buffer-stats-snapshot resource interface interface{priority-group
{ id | all } | queue { ucast{id | all}{ mcast {id | all} | all}
show hardware drops interface interface
clear hardware stack-unit stack-unit-number counters
clear hardware stack-unit stack-unit-number unit 0-1 counters
clear hardware stack-unit stack-unit-number cpu data-plane statistics
clear hardware stack-unit stack-unit-number cpu party-bus statistics
Displaying Drop Counters
To display drop counters, use the following commands.
Identify which stack unit and port pipe is experiencing internal drops.
show hardware stack-unit stack-unit-number drops [unit unit-number]
Identify which interface is experiencing internal drops.
Debugging and Diagnostics 1252

Table of Contents

Related product manuals