Dell S4048T User Manual

pool name
2 Specify the client IP address.
DHCP <POOL>
host address
3 Specify the client hardware address.
DHCP <POOL>
hardware-address hardware-address type
• hardware-address: the client MAC address.
• type: the protocol of the hardware platform.
The default protocol is Ethernet.
Debugging the DHCP Server
To debug the DHCP server, use the following command.
• Display debug information for DHCP server.
EXEC Privilege mode
debug ip dhcp server [events | packets]
Using DHCP Clear Commands
To clear DHCP binding entries, address conflicts, and server counters, use the following commands.
• Clear DHCP binding entries for the entire binding table.
EXEC Privilege mode.
clear ip dhcp binding
• Clear a DHCP binding entry for an individual IP address.
EXEC Privilege mode.
clear ip dhcp binding ip address
Configure the System to be a Relay
Agent
DHCP clients and servers request and offer configuration information via broadcast DHCP messages. Routers
do not forward broadcasts, so if there are no DHCP servers on the subnet, the client does not receive a
response to its request and therefore cannot access the network.
You can configure an interface on the Dell Networking system to relay the DHCP messages to a specific
DHCP server using the ip helper-address dhcp-address command from INTERFACE mode, as shown
Dynamic Host Configuration Protocol (DHCP) 351

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)