The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
Sample Configurations
Before you set up VRRP, review the following sample configurations.
VRRP for an IPv4 Configuration
The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive
directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste
from the example to your CLI. To support your own IP addresses, interfaces, names, and so on, be sure that
you make the necessary changes. The VRRP topology was created using the CLI configuration shown in the
following example.
Virtual Router Redundancy Protocol (VRRP) 1222
To Next Page
Loading...
