NOTE: In order for the VRF ACLs to take effect, ACLs configured in the Layer 3 CAM region must have an
implicit-permit option.
You can use the ip access-group command to configure VRF-aware ACLs on interfaces. Using the ip
access-group command, in addition to a range of VLANs, you can also specify a range of VRFs as input for
configuring ACLs on interfaces. The VRF range is from 1 to 63. These ACLs use the existing V4 ACL CAM
region to populate the entries in the hardware and do not require you to carve out a separate CAM region.
NOTE: You can configure VRF-aware ACLs on interfaces either using a range of VLANs or a range of VRFs
but not both.
Topics:
• IP Access Control Lists (ACLs)
• Important Points to Remember
• IP Fragment Handling
• Configure a Standard IP ACL
• Configure an Extended IP ACL
• Configure Layer 2 and Layer 3 ACLs
• Assign an IP ACL to an Interface
• Applying an IP ACL
• Configure Ingress ACLs
• Configure Egress ACLs
• IP Prefix Lists
• ACL Resequencing
• Route Maps
• Logging of ACL Processes
• Flow-Based Monitoring Support for ACLs
• Configuring UDF ACL
IP Access Control Lists (ACLs)
In Dell Networking switch/routers, you can create two different types of IP ACLs: standard or extended.
A standard ACL filters packets based on the source IP packet. An extended ACL filters traffic based on the
following criteria:
• IP protocol number
• Source IP address
• Destination IP address
• Source TCP port number
• Destination TCP port number
• Source UDP port number
• Destination UDP port number
For more information about ACL options, refer to the Dell Networking OS Command Reference Guide.
Access Control Lists (ACLs) 138
To Next Page