Dell S4048T - 53 Storm Control; Configure Storm Control

Storm Control
Storm control allows you to control unknown-unicast, muticast, and broadcast traffic on Layer 2 and Layer 3
physical interfaces.
Dell Networking Operating System (OS) Behavior: Dell Networking OS supports unknown-unicast, muticast,
and broadcast control for Layer 2 and Layer 3 traffic.
Dell Networking OS Behavior: The minimum number of packets per second (PPS) that storm control can
limit on the device is two.
To view the storm control broadcast configuration show storm-control broadcast | multicast |
unknown-unicast | pfc-llfc
[interface] command.
EXEC Privilege
To view the storm control multicast configuration, use the show storm-control broadcast |
multicast | unknown-unicast | pfc-llfc [interface] command.
EXEC Privilege
Example:
Dell#show storm-control multicast Tengigabitethernet 1/1
Multicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------
Te 1/1 Ingress 5
Dell#
To display the storm control unknown-unicast configuration, use the show storm-control unknown-
unicast [interface] command.
EXEC Privilege
Configure Storm Control
Storm control is supported in INTERFACE mode and CONFIGURATION mode.
53
Storm Control 1041