Disabling Auto-Reboot
To disable auto-reboot, use the following command.
• Prevent a failed stack unit from rebooting after a failover.
CONFIGURATION mode
redundancy disable-auto-reboot
Manually Synchronizing Management and
Standby Units
To manually synchronize Management and Standby units at any time, use the following command.
• Manually synchronize Management and Standby units.
EXEC Privilege mode
redundancy synchronize full
Pre-Configuring a Stack Unit Slot
You may also pre-configure an empty stack unit slot with a logical stack unit.
To pre-configure an empty stack unit slot, use the following command.
• Pre-configure an empty stack unit slot with a logical stack unit.
CONFIGURATION mode
stack-unit unit_id provisionS4048–ON
Example of Viewing a Logical Configuration of a Pre-Configured Stack Unit
After creating the logical stack unit, you can configure the interfaces on the stack unit as if it is present.
Removing a Provisioned Logical Stack
Unit
To remove the line card configuration, use the following command.
• To remove a logical stack-unit configuration, use the following command:
CONFIGURATION mode
no stack-unit unit_id provision
High Availability (HA) 421
To Next Page
Loading...
