Dell S4048T User Manual

The following example applies the accounting default method to the user role secadmin (security
administrator).
Dell(conf-vty-0)# accounting commands role secadmin default
Displaying Active Accounting Sessions for Roles
To display active accounting sessions for each user role, use the show accounting command in EXEC mode.
Example of Displaying Active Accounting Sessions for Roles
Dell#show accounting
Active accounted actions on tty2, User john Priv 1 Role netoperator
Task ID 1, EXEC Accounting record, 00:00:30 Elapsed,
service=shell
Active accounted actions on tty3, User admin Priv 15 Role sysadmin
Task ID 2, EXEC Accounting record, 00:00:26 Elapsed,
service=shell
Display Information About User Roles
This section describes how to display information about user roles.
This sections consists of the following topics:
• Displaying User Roles
• Displaying Information About Roles Logged into the Switch
• Displaying Active Accounting Sessions for Roles
Displaying User Roles
To display user roles using the show userrole command in EXEC Privilege mode, use the show
userroles and show users commands in EXEC privilege mode.
Examples of Displaying User Roles
Dell#show userroles
Role Inheritance Modes
netoperator Exec
netadmin Exec Config Interface Line Router IP Routemap
Protocol MAC
secadmin Exec Config
sysadmin Exec Config Interface Line Router IP Routemap
Protocol MAC
testadmin netadmin Exec Config Interface Line Router IP Routemap
Protocol MAC
Security 945

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)