EasyManuals Logo

Dell S4048T User Manual

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #811 background imageLoading...
Page #811 background image
NOTE: Even after you disable ip-local-proxy-arp (no ip-local-proxy-arp) in a secondary
VLAN, Layer 3 communication may happen between some secondary VLAN hosts, until the address
resolution protocol (ARP) timeout happens on those secondary VLAN hosts.
Set the mode of the selected VLAN to community, isolated, or primary.
INTERFACE VLAN mode
[no] private-vlan mode {community | isolated | primary}
Map secondary VLANs to the selected primary VLAN.
INTERFACE VLAN mode
[no] private-vlan mapping secondary-vlan vlan-list
Display type and status of PVLAN interfaces.
EXEC mode or EXEC Privilege mode
show interfaces private-vlan [interface interface]
Display PVLANs and/or interfaces that are part of a PVLAN.
EXEC mode or EXEC Privilege mode
show vlan private-vlan [community | interface | isolated | primary |
primary_vlan | interface interface]
Display primary-secondary VLAN mapping.
EXEC mode or EXEC Privilege mode
show vlan private-vlan mapping
Set the PVLAN mode of the selected port.
INTERFACE
switchport mode private-vlan {host | promiscuous | trunk}
NOTE: Secondary VLANs are Layer 2 VLANs, so even if they are operationally down while primary VLANs
are operationally up, Layer 3 traffic is still transmitted across secondary VLANs.
NOTE: The outputs of the show arp and show vlan commands provide PVLAN data. For more
information, refer to the Dell Networking OS Command Line Reference Guide.
Configuration Task List
The following sections contain the procedures that configure a private VLAN.
Creating PVLAN Ports
Creating a Primary VLAN
Creating a Community VLAN
Creating an Isolated VLAN
Private VLANs (PVLAN) 811

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S4048T and is the answer not in the manual?

Dell S4048T Specifications

General IconGeneral
Switching Capacity1.44 Tbps
Rack Units1U
Form FactorRack-mountable
Power DeviceInternal power supply
Power RedundancyOptional
Product TypeSwitch
Jumbo Frame SupportYes
Routing ProtocolOSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management ProtocolSNMP, RMON, Telnet, SSH
FeaturesQuality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)17.3 in x 16 in x 1.7 in
Operating Temperature0°C to 40 °C
Operating Humidity10% to 90% (non-condensing)

Related product manuals