Dell S4048T User Manual

Topics:
• Configuring SupportAssist Using a Configuration Wizard
• Configuring SupportAssist Manually
• Configuring SupportAssist Activity
• Configuring SupportAssist Company
• Configuring SupportAssist Person
• Configuring SupportAssist Server
• Viewing SupportAssist Configuration
Configuring SupportAssist Using a
Configuration Wizard
You are guided through a series of queries to configure SupportAssist. The generated commands are added
to the running configuration, including the DNS resolve commands, if configured.
This command starts the configuration wizard for the SupportAssist. At any time, you can exit by entering
Ctrl-C. If necessary, you can skip some data entry.
Enable the SupportAssist service.
CONFIGURATION mode
support-assist activate
Dell(conf)#support-assist activate
This command guides you through steps to configure SupportAssist.
Configuring SupportAssist Manually
To manually configure SupportAssist service, use the following commands.
1 Accept the end-user license agreement (EULA).
CONFIGURATION mode
eula-consent {support-assist} {accept | reject}
NOTE: Once accepted, you do not have to accept the EULA again.
Dell(conf)# eula-consent support-assist accept
I accept the terms of the license agreement. You can reject
the license agreement by configuring this command
'eula-consent support-assist reject'.
By installing SupportAssist, you allow Dell to save your
contact information (e.g. name, phone number and/or
email address) which would be used to provide technical
support for your Dell products and services. Dell may use
SupportAssist 1063

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)