login authentication {method-list-name | default}
Example of a Failed Authentication
To view the configuration, use the show config in LINE mode or the show running-config tacacs+
command in EXEC Privilege mode.
If authentication fails using the primary method, Dell Networking OS employs the second method (or third
method, if necessary) automatically. For example, if the TACACS+ server is reachable, but the server key is
invalid, Dell Networking OS proceeds to the next authentication method. In the following example, the
TACACS+ is incorrect, but the user is still authenticated by the secondary method.
First bold line: Server key purposely changed to incorrect value.
Second bold line: User authenticated using the secondary method.
Dell(conf)#
Dell(conf)#do show run aaa
!
aaa authentication enable default tacacs+ enable
aaa authentication enable LOCAL enable tacacs+
aaa authentication login default tacacs+ local
aaa authentication login LOCAL local tacacs+
aaa authorization exec default tacacs+ none
aaa authorization commands 1 default tacacs+ none
aaa authorization commands 15 default tacacs+ none
aaa accounting exec default start-stop tacacs+
aaa accounting commands 1 default start-stop tacacs+
aaa accounting commands 15 default start-stop tacacs+
Dell(conf)#
Dell(conf)#do show run tacacs+
!
tacacs-server key 7 d05206c308f4d35b
tacacs-server host 10.10.10.10 timeout 1
Dell(conf)#tacacs-server key angeline
Dell(conf)#%RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user admin on
vty0 (10.11.9.209)
%RPM0-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
%RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user admin on line
vty0 (10.11.9.209)
Dell(conf)#username angeline password angeline
Dell(conf)#%RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user angeline
on vty0 (10.11.9.209)
%RPM0-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
Monitoring TACACS+
To view information on TACACS+ transactions, use the following command.
• View TACACS+ transactions to troubleshoot problems.
EXEC Privilege mode
debug tacacs+
Security 921
To Next Page
Loading...
