EasyManuals Logo

Dell S4048T User Manual

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #897 background imageLoading...
Page #897 background image
no spanning-tree 0
Modifying Global Parameters
You can modify RSTP parameters.
The root bridge sets the values for forward-delay, hello-time, and max-age and overwrites the values set on
other bridges participating in the Rapid Spanning Tree group.
Forward-delay — the amount of time an interface waits in the Listening state and the Learning state
before it transitions to the Forwarding state.
Hello-time — the time interval in which the bridge sends RSTP BPDUs.
Max-age — the length of time the bridge maintains configuration information before it refreshes that
information by recomputing the RST topology.
NOTE
: Dell Networking recommends that only experienced network administrators change the Rapid
Spanning Tree group parameters. Poorly planned modification of the RSTP parameters can negatively
affect network performance.
The following table displays the default values for RSTP.
Table 79. RSTP Default Values
RSTP Parameter Default Value
Forward Delay 15 seconds
Hello Time 2 seconds
Max Age 20 seconds
Port Cost:
100-Mb/s Ethernet interfaces
1-Gigabit Ethernet interfaces
10-Gigabit Ethernet interfaces
40-Gigabit Ethernet interfaces
Port Channel with 100 Mb/s Ethernet interfaces
Port Channel with 1-Gigabit Ethernet interfaces
Port Channel with 10-Gigabit Ethernet
interfaces
Port Channel with 40-Gigabit Ethernet
interfaces
Port Cost:
200000
20000
2000
1400
180000
18000
1800
600
Port Priority 128
To change these parameters, use the following commands.
Change the forward-delay parameter.
PROTOCOL SPANNING TREE RSTP mode
forward-delay seconds
The range is from 4 to 30.
Rapid Spanning Tree Protocol (RSTP) 897

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell S4048T and is the answer not in the manual?

Dell S4048T Specifications

General IconGeneral
Switching Capacity1.44 Tbps
Rack Units1U
Form FactorRack-mountable
Power DeviceInternal power supply
Power RedundancyOptional
Product TypeSwitch
Jumbo Frame SupportYes
Routing ProtocolOSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management ProtocolSNMP, RMON, Telnet, SSH
FeaturesQuality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)17.3 in x 16 in x 1.7 in
Operating Temperature0°C to 40 °C
Operating Humidity10% to 90% (non-condensing)

Related product manuals