Dell S4048T - Configuring the Dynamic Buffer Method

dot1p Value in
the Incoming
Frame
Egress Queue Assignment
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
dot1p Value in
the Incoming
Frame
Egress Queue Assignment
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Configuring the Dynamic Buffer
Method
Priority-based flow control using dynamic buffer spaces is supported on the switch.
To configure the dynamic buffer capability, perform the following steps:
1 Enable the DCB application. By default, DCB is enabled and link-level flow control is disabled on all
interfaces.
CONFIGURATION mode
dcb enable
2 Configure the shared PFC buffer size and the total buffer size. A maximum of 4 lossless queues are
supported.
CONFIGURATION mode
Data Center Bridging (DCB) 339