Dell S4048T - Page 1200

00:09:06
===================================================================================
===
The following shows the output of the show commands on Router 2.
Router 2
Dell#show ip vrf
VRF-Name VRF-ID Interfaces
default-vrf 0 Te 3/0-3,
Te
2/0-17,21-47,
Ma 0/0,
Ma 1/0,
Nu 0,
Vl 1
blue 1 Te 2/1,
Vl 128
orange 2 Te 2/2,
Vl 192
green 3 Te 2/3,
Vl 256
Dell#show ip ospf 1 neighbor
Neighbor ID Pri State Dead Time Address Interface
Area
1.0.0.1 1 FULL/BDR 00:00:36 1.0.0.1 Vl
128 0
!
Dell#sh ip ospf 2 neighbor
Neighbor ID Pri State Dead Time Address Interface
Area
2.0.0.1 1 FULL/BDR 00:00:33 2.0.0.1 Vl
192 0
!
Dell#show ip route vrf blue
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last
Change
----------- ------- -----------
-----------
C 1.0.0.0/24 Direct, Vl 128 0/0
00:27:21
O 10.0.0.0/24 via 1.0.0.1, Vl 128 110/2
00:14:24
C 11.0.0.0/24 Direct, Te 2/1 0/0
00:19:46
Dell#show ip route vrf orange
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
Virtual Routing and Forwarding (VRF) 1200