Dell S4048T - Page 1250

To display the default buffer profile, use the show buffer-profile {summary | detail} command
from EXEC Privilege mode.
The following example shows viewing the default buffer profile.
Dell#show buffer-profile detail interface tengigabitethernet 1/1
Interface Te 1/1
Buffer-profile -
Dynamic buffer 194.88 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 2.50 256
1 2.50 256
2 2.50 256
3 2.50 256
4 9.38 256
5 9.38 256
6 9.38 256
7 9.38 256
The following example shows viewing the buffer profile allocations.
Dell#show running-config interface tengigabitethernet 2/1 !
interface TenGigabitEthernet 2/1
no ip address
mtu 9216
switchport
no shutdown
buffer-policy myfsbufferprofile
The following example shows viewing the default buffer profile on an interface.
Dell#show buffer-profile detail interface tengigabitethernet 1/10
Interface Te 1/10
Buffer-profile fsqueue-fp
Dynamic buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256
The following example shows viewing the default buffer profile on a linecard.
Dell#sho buffer-profile detail fp-uplink stack-unit 1 port-set 0
Stack Unit 1 Port-set 0
Buffer-profile fsqueue-hig
Dynamic Buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
Debugging and Diagnostics 1250