Dell S4048T

Change the IS-IS Metric Style in One Level Only...................................................... 575
Leaks from One Level to Another................................................................................. 577
Sample Configurations..........................................................................................................578
28 Link Aggregation Control Protocol (LACP)...................................................................581
Introduction to Dynamic LAGs and LACP.........................................................................581
Important Points to Remember.....................................................................................581
LACP Modes...................................................................................................................... 582
Configuring LACP Commands......................................................................................582
LACP Configuration Tasks....................................................................................................583
Creating a LAG..................................................................................................................583
Configuring the LAG Interfaces as Dynamic..............................................................584
Setting the LACP Long Timeout................................................................................... 584
Monitoring and Debugging LACP.................................................................................585
Shared LAG State Tracking...................................................................................................585
Configuring Shared LAG State Tracking......................................................................586
Important Points about Shared LAG State Tracking.................................................588
LACP Basic Configuration Example................................................................................... 588
Configure a LAG on ALPHA........................................................................................... 588
29 Layer 2.................................................................................................................................. 597
Manage the MAC Address Table......................................................................................... 597
Clearing the MAC Address Table...................................................................................597
Setting the Aging Time for Dynamic Entries...............................................................597
Configuring a Static MAC Address............................................................................... 598
Displaying the MAC Address Table...............................................................................598
MAC Learning Limit............................................................................................................... 598
Setting the MAC Learning Limit.................................................................................... 599
mac learning-limit Dynamic.......................................................................................... 599
mac learning-limit mac-address-sticky......................................................................600
mac learning-limit station-move................................................................................. 600
mac learning-limit no-station-move.......................................................................... 600
Learning Limit Violation Actions....................................................................................601
Setting Station Move Violation Actions........................................................................601
Recovering from Learning Limit and Station Move Violations...............................602
NIC Teaming...........................................................................................................................602
Configure Redundant Pairs..................................................................................................604
Important Points about Configuring Redundant Pairs............................................ 606
Far-End Failure Detection.................................................................................................... 607
FEFD State Changes........................................................................................................ 608
Configuring FEFD............................................................................................................. 610
Enabling FEFD on an Interface.......................................................................................611
9.10(0.1)
19