EasyManua.ls Logo

Dell S4048T - Page 233

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
neighbor ip-address peer-group peer-group-name
6 Add a neighbor as a remote AS.
CONFIG-ROUTERBGP mode
neighbor {ip-address | peer-group name} remote-as as-number
Formats: IP Address A.B.C.D
Peer-Group Name: 16 characters.
as-number: the range is from 0 to 65535 (2-Byte) or 1 to 4294967295 | 0.1 to 65535.65535 (4-
Byte) or 0.1 to 65535.65535 (Dotted format)
To add an external BGP (EBGP) neighbor, configure the as-number parameter with a number different
from the BGP as-number configured in the router bgp as-number command.
To add an internal BGP (IBGP) neighbor, configure the as-number parameter with the same BGP as-
number configured in the
router bgp as-number command.
Examples of Viewing and Configuring Peer Groups
After you create a peer group, you can use any of the commands beginning with the keyword neighbor to
configure that peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured parameters.
A neighbor cannot become part of a peer group if it has any of the following commands configured:
neighbor advertisement-interval
neighbor distribute-list out
neighbor filter-list out
neighbor next-hop-self
neighbor route-map out
neighbor route-reflector-client
neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the neighbor’s configuration is
more specific than the peer group’s and if the neighbor’s configuration does not affect outgoing updates.
NOTE: When you configure a new set of BGP policies for a peer group, always reset the peer group by
entering the clear ip bgp peer-group peer-group-name command in EXEC Privilege mode.
To view the configuration, use the show config command in CONFIGURATION ROUTER BGP mode.
When you create a peer group, it is disabled (shutdown). The following example shows the creation of a peer
group (zanzibar) (in bold).
Dell(conf-router_bgp)#neighbor zanzibar peer-group
Dell(conf-router_bgp)#show conf
!
router bgp 45
bgp fast-external-fallover
bgp log-neighbor-changes
neighbor zanzibar peer-group
neighbor zanzibar shutdown
neighbor 10.1.1.1 remote-as 65535
neighbor 10.1.1.1 shutdown
Border Gateway Protocol IPv4 (BGPv4) 233

Table of Contents

Related product manuals