• ets-conf: enables transmission of ETS Configuration TLVs.
• ets-reco: enables transmission of ETS Recommend TLVs.
• pfc: enables transmission of PFC TLVs.
NOTE: You can configure the transmission of more than one TLV type at a time. You can only
enable ETS recommend TLVs (ets-reco) if you enable ETS configuration TLVs (ets-conf). To
disable TLV transmission, use the no form of the command; for example, no advertise DCBx-
tlv pfc ets-reco
.
The default is All TLV types are enabled.
5 Configure the Application Priority TLVs that advertise on unconfigured interfaces with a manual port-
role.
PROTOCOL LLDP mode
[no] advertise DCBx-appln-tlv {fcoe | iscsi}
• fcoe: enables the advertisement of FCoE in Application Priority TLVs.
• iscsi: enables the advertisement of iSCSI in Application Priority TLVs.
The default is Application Priority TLVs are enabled and advertise FCoE and iSCSI.
NOTE: To disable TLV transmission, use the no form of the command; for example, no advertise
DCBx-appln-tlv iscsi.
6 Configure the FCoE priority advertised for the FCoE protocol in Application Priority TLVs.
PROTOCOL LLDP mode
[no] fcoe priority-bits priority-bitmap
The priority-bitmap range is from 1 to FF.
The default is 0x8.
7 Configure the iSCSI priority advertised for the iSCSI protocol in Application Priority TLVs.
PROTOCOL LLDP mode
[no] iscsi priority-bits priority-bitmap
The priority-bitmap range is from 1 to FF.
The default is 0x10.
DCBx Error Messages
The following syslog messages appear when an error in DCBx operation occurs.
LLDP_MULTIPLE_PEER_DETECTED: DCBx is operationally disabled after detecting more
than one DCBx
peer on the port interface.
LLDP_PEER_AGE_OUT: DCBx is disabled as a result of LLDP timing out on a DCBx peer
interface.
DSM_DCBx_PEER_VERSION_CONFLICT: A local port expected to receive the IEEE, CIN, or
CEE version
Data Center Bridging (DCB) 326
To Next Page
Loading...
