Dell S4048T - Page 42

Table 1. Dell Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC
Dell>
Access the router through the
console or terminal line.
EXEC Privilege
Dell#
• From EXEC mode, enter the
enable command.
• From any other mode, use
the end command.
CONFIGURATION
Dell(conf)#
• From EXEC privilege mode,
enter the configure
command.
• From every mode except
EXEC and EXEC Privilege,
enter the exit command.
NOTE: Access all of the
following modes from
CONFIGURATION mode.
AS-PATH ACL
Dell(config-as-path)# ip as-path access-list
10 Gigabit Ethernet Interface
Dell(conf-if-te-1/1)#
interface (INTERFACE modes)
40 Gigabit Ethernet Interface
Dell(conf-if-fo-1/52)#
interface (INTERFACE modes)
Interface Group
Dell(conf-if-group)# interface(INTERFACE modes)
Interface Range
Dell(conf-if-range)#
interface (INTERFACE modes)
Loopback Interface
Dell(conf-if-lo-0)#
interface (INTERFACE modes)
Management Ethernet Interface
Dell(conf-if-ma-1/1)#
interface (INTERFACE modes)
Null Interface
Dell(conf-if-nu-0)#
interface (INTERFACE modes)
Port-channel Interface
Dell(conf-if-po-1)#
interface (INTERFACE modes)
Tunnel Interface
Dell(conf-if-tu-1)#
interface (INTERFACE modes)
VLAN Interface
Dell(conf-if-vl-1)#
interface (INTERFACE modes)
STANDARD ACCESS-LIST
Dell(config-std-nacl)#
ip access-list standard (IP
ACCESS-LIST Modes)
EXTENDED ACCESS-LIST
Dell(config-ext-nacl)#
ip access-list extended (IP
ACCESS-LIST Modes)
IP COMMUNITY-LIST
Dell(config-community-
list)#
ip community-list
AUXILIARY
Dell(config-line-aux)#
line (LINE Modes)
CONSOLE
Dell(config-line-console)#
line (LINE Modes)
VIRTUAL TERMINAL
Dell(config-line-vty)#
line (LINE Modes)
Configuration Fundamentals 42