EasyManua.ls Logo

Dell S4048T - Page 815

Dell S4048T
1277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Add one or more host ports to the VLAN.
INTERFACE VLAN mode
tagged interface or untagged interface
You can enter the interfaces singly or in range format, either comma-delimited (slot/
port,port,port
) or hyphenated (slot/ port-port).
You can only add ports defined as host to the VLAN.
Example of Configuring Private VLAN Members
The following example shows the use of the PVLAN commands that are used in VLAN INTERFACE mode to
configure the PVLAN member VLANs (primary, community, and isolated VLANs).
Dell#conf
Dell(conf)# interface vlan 10
Dell(conf-vlan-10)# private-vlan mode primary
Dell(conf-vlan-10)# private-vlan mapping secondary-vlan 100-101
Dell(conf-vlan-10)# untagged Te 2/1
Dell(conf-vlan-10)# tagged Te 2/3
Dell(conf)# interface vlan 101
Dell(conf-vlan-101)# private-vlan mode community
Dell(conf-vlan-101)# untagged Te 2/10
Dell(conf)# interface vlan 100
Dell(conf-vlan-100)# private-vlan mode isolated
Dell(conf-vlan-100)# untagged Te 2/2
Private VLANs (PVLAN) 815

Table of Contents

Related product manuals