Dell S4048T User Manual

• bucket-number: (Optional) a value associated with the number of buckets specified for the RMON
collection history group of statistics. The value is limited to from 1 to 1000. The default is 50 (as
defined in RFC-2819).
• interval: (Optional) specifies the number of seconds in each polling cycle.
• seconds: (Optional) the number of seconds in each polling cycle. The value is ranged from 5 to
3,600 (Seconds). The default is 1,800 (as defined in RFC-2819).
Example of the rmon collection history Command
To remove a specified RMON history group of statistics collection, use the no form of this command.
The following command example enables an RMON MIB collection history group of statistics with an ID
number of 20 and an owner of john, both the sampling interval and the number of buckets use their
respective defaults.
Dell(conf-if-mgmt)#rmon collection history controlEntry 20 owner john
Remote Monitoring (RMON) 891

Dell S4048T Specifications

General

Switching Capacity	1.44 Tbps
Rack Units	1U
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Optional
Product Type	Switch
Jumbo Frame Support	Yes
Routing Protocol	OSPF, BGP, RIP, VRRP, PIM-SM, IGMP
Remote Management Protocol	SNMP, RMON, Telnet, SSH
Features	Quality of Service (QoS), Jumbo Frames Support, Virtual Route Redundancy Protocol (VRRP), VLAN support, sFlow, Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), IPv6 support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3ae
Dimensions (W x D x H)	17.3 in x 16 in x 1.7 in
Operating Temperature	0°C to 40 °C
Operating Humidity	10% to 90% (non-condensing)