dtec DYNertia3 - User Testing Load Control; User Load Control; User Mode Editor; Saving and Loading Timelines

www.dtec.net.au
140
Chapter 16: Load Controllers
User testing load control
User Load Control: Enable ‘User’ testing. You can allow the dyno to
perform a ‘User’ test by allowing the RPM/speed to vary in a manner freely
determined by the ‘Time line’ profile.
User Mode Editor: Opens the ‘User Editor’ Window below for adjusting the
settings associated with ‘User’ testing.
We call the values to give the desired steps a “Time Line”.
Tip- During testing the throttle can also be
freely controlled.
Saving and Loading Timelines: You can save the Time Line settings if you wish (or load already
saved ones) by using the ‘disc’ buttons.
After the ‘Step Editor’ is closed the Load Control window will now display the selected steps as a preview.
Press the “USER START” button and DYnertia3 will start waiting for the test to start.
Accelerate the engine until the start RPM is reached; it will then follow the set profiles automatically and end the test
when the end RPM is reached.
Tip- During the test the progress is best viewed on the “Graph” Window displayed on a second monitor.