www.dtec.net.au
Chapter 13: Analysing Data (‘View’ Menu)
Compare
Compares the percentage of difference between all selected Run traces (any data set) and highlights variations.
Individual data channels for the chosen traces can be turned on/off (‘eye’ visibility buttons in the menu bar) and the trace
being viewed can be from any of those loaded and selected into the main dyno ‘GRAPH’ Window. Only available traces
and their active data channels will have the buttons highlighted for operation!
The reference trace is the one that all others are compared to. The difference percentages
displayed in the data box’s in the right hand side are relative to this selected trace.
Select Traces to compare: Choose to view the traces loaded in the Main dyno ‘GRAPH’ Window or
those loaded in the Secondary Graph Window.
Tip- The RPM scale is taken from the main GRAPH Window, so trimming the main graph (e.g. using the corner arrows)
will vary what is seen in this screen.
To Next Page
Loading...