www.dtec.net.au
Chapter 2: Hardware Installation
‘Linking’ Hardware to PC
Do not run other programs when using DYNertia3, background processes could interfere.
1. When you first run DYNertia3 you will be shown this Window. Press the “Continue OFFLINE” button, this is
necessary as DYNertia3 software does not yet know what PC communication port your control units are connected
to, it must be first ‘Linked’.
Once ‘Linked’ DYNertia3 will automatically find the hardware in future when it is connected, powered and the software is
started. If you plug DYNertia3 or Load Controller hardware into another USB port you may need to re-link.
This Window will also appear whenever DYNertia3 is started and the control units are not connected, powered or
‘Linked’. Pressing the “Continue OFFLINE” button allows you to continue to use DYNertia3 to view and analyse data ‘off-
line’ (i.e. with no hardware connected to the PC).
2. Power your DYNertia3 and Load Control units and plug the USB in, start DYNertia3 software, select the menu option
“Setup” and then choose “Communication” and then press the “LINK” button to DYNertia3 to automatically configure
the port interface. Then repeat for ‘Load Controller’ or ‘Weather Watch’ if connected.
To Next Page
Loading...