www.dtec.net.au
Chapter 8: Loading / Viewing Files
Reviewing Audio Files
Audio files can be used to save a commentary during a test or to record the actual engine noise.
If the ‘Media‘ option in the menu choice “Setup/Software/General” is
enabled then there will be audio files (.wav) visible along with the normal
‘run’ files (.DYN3) in ‘DYNertia3 File Explorer’ (assuming you have some
audio tracks recorded).
Recording audio files is done by pressing the ‘Mic Input’ button on the ‘Graph’ or ‘Dyno’ screen (turns
microphone on/off) to record during the duration of the run. An audio file (.wav) will be saved along with the
completed run file. This can be used to save a commentary during a test or to record the actual engine noise.
‘Clicking’ on the audio files name will open a small Window allowing the file to be played and reviewed.
The controls are standard audio symbols with the exception of the middle ‘Loop’ button that sets a repeat play function.
The section of recording can be narrowed down by using the ‘Mark In and Mark Out’ controls, these determine the start
and finish time of the recording that is actually played back.
To Next Page
Loading...
Need help?
General