www.dtec.net.au
Chapter 4: ‘Setup’ Menu Options
Printer
See chapter “Printing and exporting” for full details.
PRM/Speed Source
Selects the RPM/Speed source to be used.
See chapter “RPM Input Options” for full details.
Note: The option to use ‘RPM Input’ is only visible if in the menu option
‘Setup/Hardware’ it is enabled and configured.
Note: OBDII diagnostic port reader is not available at time of this manual.
Sensor Configuration
See chapter “Inputs- Using” for full details, load cell calibration is also found in this menu choice, some additional
information regarding this is also in the ‘Load Controller’ chapter.
Data Limits / Alarms
See chapter “Inputs- Using” for full details.
Losses Systems
Refer to chapter ‘Losses Systems’ for detailed information.
Main Graph Trace Colour (Visible only from ‘Graph’ screen)
You can select a new colour for any of the traces individually here.
You can select any display colour from the pallet to associate with selected trace number, it will be
stored permanently.
Tip- The colours chosen are also used for printing (on a white background), so keep this in mind and
avoid very light colours if printing is planned.
Grid
Set if the main graph is to have a grid displayed as background behind the graph traces.
Operator
Allows entry of the operators name, this can be transferred with the comments (see “Setup Software” chapter) and will
also appear on the printouts.
To Next Page
Loading...