www.dtec.net.au
Chapter 11: Printing & Exporting
Customising your printout
The logo in the printouts can be user defined. It must be a ‘BMP’ image, it should have a 2:1 aspect ratio to appear
undistorted when viewed. In the menu “Setup/Software” is a button that opens the user details form as below-
User Details and Company Logo: Data and your logo image used here
appears on the printouts. The logo can be inserted by pressing the
“Add“ button or if you do not wish to use a logo, press “X” button.
The user details appear on the detailed and summary printouts.
Customer Disclaimer: A disclaimer notice can be saved and printed for issuing to the customer prior to dyno testing. It
is up to the user to produce a legally binding disclaimer in line with their local regulations.
When the print button is pressed a form opens to allow vehicle information
to be entered and this will be added to printouts.
The name of operator can appear on the printout, if desired, by pressing the user button when shown.
The detailed printout option allows greater information to be displayed; it appears on the 2
nd
page and is
entered by using the comments button.
In some screens this button will open a general comments form that will generate notes that can be placed on the actual
graph, see “Notes To Print” section for details.
To Next Page
Loading...