www.dtec.net.au
Chapter 17: Losses Correction
Configuration Window
Losses system can be accessed from the menu “Setup/Losses Systems” or by pressing
the Icon that appears on the DYNO and GRAPH Windows (a stylized Bearing Block).
Whenever losses of any type is enabled
the Icon that appears on the DYNO and
GRAPH Window will be green.
The losses configuration Window shown allows the choice of ‘Estimated’ or ‘Measured’ dyno loss correction.
Note: The comments that appear during the process are very descriptive; please read them carefully as you progress.
To Next Page
Loading...
Need help?
General