www.dtec.net.au
STOP !!!
Please read the appropriate ‘Quick Start’ guide for your dyno
type (Chassis or Engine & Inertia or Brake) first.
Actual testing is outlined there!!!
This ‘full’ manual contains much detail; by reading the ‘Quick Start’
guide first you will gain a basic understanding of the concepts and
key points required.
There are sample files installed along with DYNertia3 software so you can connect
the hardware and learn to use many of the features without needing to perform actual
tests. It is much easier to study without the noise of a screaming engine!
All examples in this manual use ‘Metric’ units such as kph/Kw/Nm etc. DYNertia3 can
be set in the software to ‘Imperial’ if you prefer mph/Hp/Ft Lb etc!
To Next Page
Loading...